Table of Contents
Advertisement
AU
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
Operation
Control Panel
The control panel is located below the door at the
front of the appliance.
Turn On
1. Close the door of the appliance.
2. Connect the appliance to a mains power
supply.
3. Press the Power switch (Green) to the On
position.
4
GC870-A_GC871-A_CS627-A_CS628-A_A5_v2_170829.indb 4
Telephone Helpline: 1300225960
Internal Light
The light switch is located at the front of the
appliance next to the power switch.
Set the Operating Temperature
1. Press the SET button. The display will flash.
2. Press the
or
button to display the
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
Press and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
Cleaning, Care &
Maintenance
Switch off and disconnect
from the power supply before
cleaning.
•
The doors can be removed for ease of
cleaning.
•
Clean the interior of the appliance as often as
possible.
•
Do not use abrasive cleaning agents. These
can leave harmful residues.
•
Clean the door seal with warm soapy water.
•
Always wipe dry after cleaning.
•
Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
Replacing the Interior Lamp
Call your dealer or a qualified electrician, the Lamp
Assembly is available to purchase as a spare part.
Cleaning the Condenser
Periodic cleaning of the Condenser can extend
the life of the appliance. POLAR recommend that
a POLAR agent or qualified technician clean the
condenser.
2017/8/29 17:50
Advertisement
Table of Contents
