Advertisement
3
Dry the sensitive area cap before you use or store it.
Note: Make sure the sensitive area cap is completely dry before you place it back onto
the epilating head.
Cleaning the epilating head
1
Push the epilating head in the direction of the arrows on the back of the
appliance (1) and remove it (2) (Fig. 14).
2
Rinse the epilating head under the tap for 5-10 seconds while turning it.
3
Shake the epilating head firmly (Fig. 15).
4
Dry the epilating head thoroughly with a tea towel.
Note: Make sure the epilating head is completely dry before you place it back onto the
appliance.
Replacement
All parts of the appliance can be replaced. If you need to replace one of the parts, go
to your Philips dealer or an authorised Philips service centre.
Environment
-
Do not throw away the appliance with the normal household waste at the end
of its life, but hand it in at an official collection point for recycling. By doing this,
you help to preserve the environment (Fig. 16).
Guarantee and service
If you need service or information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Consumer Care Centre in your
country (you find its phone number in the worldwide guarantee leaflet). If there is no
Consumer Care Centre in your country, go to your local Philips dealer.
Troubleshooting
This chapter summarises the most common problems you could encounter with the
appliance. If you are unable to solve the problem with the information below, contact
the Consumer Care Centre in your country.
Problem
Cause
Poor epilating
You are moving
results
the appliance in the
wrong direction.
You are placing
the epilating head on
the skin at a wrong
angle.
You used a (depilatory)
cream prior to
epilation.
The hairs are too
short.
The sensitive area
cap is attached to the
epilating head while
you epilate your legs.
3
Solution
Move the appliance against the
direction of hair growth, with the on/off
slide pointing in the direction in which
you move the appliance.
Make sure that you place the appliance
on the skin at an angle of 90° (see
chapter 'using the appliance').
Make sure your skin is clean, entirely
dry and free from grease. Do not use
any cream before you start epilating.
The optimal hair length for easy
removal of the hairs is 3-4mm. If the
hairs are too short, wait until they are
longer or try to remove the hairs by
repeatedly moving the appliance across
the skin.
Do not use the sensitive area cap
when you epilate your legs, as the cap
reduces the number of active epilating
discs. Never use the epilator without
the sensitive area cap when you epilate
your underarms.
4203.000.6736.1
Advertisement
