Philips HP6360/00 User Manual page 3

ENGLISH
3
4 Reassemble the cutting element by inserting the
hook into the slot in the cavity and pushing the
cutting element back onto the appliance until
you hear a click (fig. 11).
Replacement
.
A worn or damaged cutting element should only be
replaced with an original Philips/Philishave cutting
element.
1 Remove the old cutting element.
2 Push the new cutting element onto the
appliance until you hear a click.
Environment
.
The built-in rechargeable battery contains substances
that may pollute the environment.
Remove the battery when you discard the appliance.
Do not throw the battery away with the normal
household waste, but hand it in at an official
collection point. You can also take the appliance to a
Philips service centre, which will remove the battery
for you and will dispose of it in an environmentally
safe way.
1 Disconnect the appliance from the mains and
let the appliance run until the motor stops.
2 Insert a screwdriver between the two housing
halves next to the motor shaft and pry them
apart (fig. 12).
3 Pull the rechargeable battery and the on/off
circuit board out of the housing (fig. 13).
4 Insert the screwdriver into the small slot in the
printed circuit board marked with an arrow.
Push the screwdriver down until part of the
printed circuit board breaks off (fig. 14).
5 Remove the battery from the plastic part by
means of a screwdriver.
Do not connect the appliance to the mains again
after the battery has been removed.
Guarantee & service
.
If you need information or if you have a problem,
please visit the Philips website at www.philips.com
or contact the Philips Customer Care Centre in your
country (you will find its phone number in the
worldwide guarantee leaflet). If there is no
Customer Care Centre in your country, turn to your
local Philips dealer or contact the Service
Department of Philips Domestic Appliances and
Personal Care BV.
HP6360 4203 000 30931