Smartswitch Codes Recap - Inferno Wicked Lasers User's Manual And Safety Manual

WWW.W I CK E D L AS ER S. C OM
Using Your Laser : The SmartSwitch
To summarize:
This is the first code you should remember
short holds
(press and hold the button briefly for less than 1 sec.) will unlock the laser.
Once the power is on, the user can toggle between
the different active modes all available in low power
and high power: Strobe, Constant Wave, SOS and
Beacon Mode with a few simple clicks.
There is also the Tactical hibernation mode which
allows you to shut off the laser and quickly re-
enable it with the last setting it was on.
S3 In fe r n o Se ri es | 8
three quick clicks + two
The following 9 modes are enabled by using
the SmartSwitch™ 2.0:
▪ Strobe Mode (Hi / Low)
▪ Constant Wave (Hi / Low)
▪ SOS (Hi / Low)
▪ Beacon (Hi / Low)
▪ Tactical Hibernation Mode
Using Your Laser : The SmartSwitch
SmartSwitch 2.0™ Codes:
After unlocking your laser, you can select among the active modes by using one of these following codes when
pressing the button:
▪ A short hold cycles between high power and low power.
▪ A quick click cycles Strobe mode to Constant Wave mode.
▪ Clicking quickly 3 times within 2 seconds goes into SOS mode.
▪ From SOS mode, one quick click will change it into Beacon mode.
▪ From Beacon mode, one quick click will change it to low power Strobe mode.
▪ Holding the switch for 3 seconds will go to Tactical Hibernation mode. The middle LED will be
flashing to indicate this.
Us er's M anual & La se r Sa fe ty G u ide | 9