Download Print this page

Omega National Products KitchenMate Blind Corner Caddy Assembly Instructions

Download this manual

KitchenMate

• Always read the instructions completely and carefully before beginning assembly.

• Remove and check contents for damage and/or missing parts. Keep the original

cartons and packing materials, which are required for any authorized adjustment by

our dealers.

• These instructions are for reference only. Make sure installation procedures comply

with all applicable building codes in your area.

Assembly Instructions

Step 1:

Turn drawer unit vertical with drawer fronts up

and slide unit into cabinet (See figure 1)

Blind Corner Caddy

P0650MNL1

Important Notes

Notes:

Cabinet door opening must

be a minimun of 15 inches

wide to install this unit.

To allow corner caddy to

work properly cabinet door

must be attached to oppo-

site side of door opening

from corner caddy

Remove Cabinet door for

ease of installation.

Figure 1

Drawer Unit

Form OME-063, 01/2007

Need help?

Do you have a question about the KitchenMate Blind Corner Caddy and is the answer not in the manual?

Page 1 Remove Cabinet door for ease of installation. Step 1: Turn drawer unit vertical with drawer fronts up Figure 1 and slide unit into cabinet (See figure 1) Drawer Unit Form OME-063, 01/2007 ©Omega National Products...
Page 2 Fasten slide assembly to cabinet side panel using (4) #6 x 1 1/4" screws. (See figure 4) #6 x 1 1/4" Screws Form OME-063, 01/2007 ©Omega National Products...
Page 3 (See figure 5) Step 6: Pull follower unit out and fasten caddy Figure 6 to follower using (3) #6 x 1 1/4" screws. (See figure 6). (3) #6 x 1 1/4" Screws Form OME-063, 01/2007 ©Omega National Products...

P0650mnl1