Toro STX-26 Service Bulletin page 3

STX-26 JOYSTICK INSTRUCTIONS
1. Remove the button boot from the joystick lever (Fig.
01).
2. Remove the actuator button from the joystick lever
(Fig. 02).
3. With a T10 TORX driver, remove the four screws
retaining the rear handle half (Fig. 03).
Fig. 01 DSCN-4410a
Fig. 02 DSCN-4414a
Fig. 03 DSCN-4415a
4. Carefully remove the rear handle half (Fig. 04).
5. Carefully remove the front handle half from the
square post and reinstall it with the lever facing the
side with the wire protruding out (Fig. 05).
6. Reinstall the rear handle half and install and tighten
the four screws (Fig. 06).
Fig. 04 DSCN-4419a
Fig. 05 DSCN-4420 & DSCN4421a
Fig. 06 DSCN-4425a
1