U-Line H-4026 Operating Instructions
U-Line H-4026 Operating Instructions

U-Line H-4026 Operating Instructions

Portable blower
Hide thumbs Also See for H-4026:

Advertisement

π
H-4026, H-4027
PORTABLE BLOWER
NOTE: Save these instructions.

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic precautions
should always be followed, including the following:
WARNING! Read all instructions before using
this portable blower.
To reduce the risk of fire, electric shock, or injury:
• Do not use machine in standing water.
• Avoid electrical shock; do not handle the plug or
machine with wet hands. To unplug the cord, grasp
the plug. Do not pull on the cord.
• Use machine only as described in this manual. Do
not use in ways it was not intended.
• Turn off all switches and unplug the electrical cord
when not in use and before servicing.
• Do not allow to be used by untrained personnel.
Close attention is necessary when used near
children.
• If the machine is not working as it should, has been
dropped, damaged, or left outdoors, call Uline
Repairs team before using.
• Do not operate portable blower if cord is damaged.
Call Uline Repairs team for repair information.
• Do not run the power cord under carpeting, throw
rugs, runners or similar coverings. Place the power
cord away from traffic areas to prevent tripping.
PAGE 1 OF 4
1-800-295-5510
uline.com
SAFETY
• Do not use extension cords or outlets with
• This machine creates suction and contains a
• Do not use in areas where flammable and/or
• Do not allow air inlet openings on either side of the
• Do not allow debris near front air exhaust opening
• This unit is thermally protected.
• Use only on GFCI-protected receptacles.
• Use indoors only. Do not use outdoors or expose
• Do not use an extension cord with this blower.
• Do not direct air flow at face or any part of body.
• Do not use the portable blower with any solid-state
inadequate current-carrying capacity. Do not
use with a damaged cord or plug. Connect the
machine only to a properly grounded outlet (refer to
Grounding). Avoid damaging cord (closing doors
on cord, pulling around sharp edges or corners, hot
surfaces, or running machine over cord).
revolving fan. Keep hair, loose clothing, fingers, and
all other parts of the body away from openings and
moving parts. Do not insert any objects into the
openings of the machine.
explosive vapor or dust is present to avoid the
possibility of fire or explosion. Some cleaning fluids
can produce such vapors.
machine to be obstructed; this could cause the
motor to overheat.
which could be thrown by the air stream.
to rain.
speed control device.
0415 IH-4026

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the H-4026 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for U-Line H-4026

  • Page 1 π H-4026, H-4027 1-800-295-5510 uline.com PORTABLE BLOWER SAFETY NOTE: Save these instructions. • Do not use extension cords or outlets with inadequate current-carrying capacity. Do not IMPORTANT SAFEGUARDS use with a damaged cord or plug. Connect the machine only to a properly grounded outlet (refer to When using an electrical appliance, basic precautions GROUNDING).
  • Page 2 3. Place the portable blower into the desired operating position (See Figures 3 and 4) while making sure NOTE: Stacking feature is unit operates normally. not secure for transportation. a. 4 airflow positions for H-4026 model: Figure 3 Figure 5 90º 0º...
  • Page 3 OPERATING CONTINUED Telescoping handle and wheels are available on H-4027 Figure 6 model. (See Figure 6) To use handle, push in release button, pull handle up until it locks into place. Tilt the unit back onto the wheels and roll to desired location. MAINTENANCE WARNING! To reduce the risk of fire, electric 3.
  • Page 4 TECHNICAL DATA MODEL H-4026 H-4027 Volt/Frequency 115V/60Hz 115V/60Hz Power 1/2 HP 1/2 HP AMPS Unit Weight 20.4 lbs 23.6 lbs Speeds Unit Size (L x W x H) 15.9 x 15.7 x 16.3 15.9 x 17 x 17.5 Telescopic Handle and Wheel...

This manual is also suitable for:

H-4027

Table of Contents