Riedel SmartPanel 1.0 1200 Series User Manual page 22

1200 Series SmartPanels 1.0 User Manual
Ø
The SmartPanel is automatically rebooting
after removing the USB pen drive.
The firmware update is finished now.
Firmware update via web interface
Enter the IP address of the AES67 interface (Ethernet connectors)
of the SmartPanel in the web browser of a PC on the same
network.
The IP addresses of the SmartPanel are displayed in the
Panel-Menu > Network > AES67.
Do not disconnect the SmartPanel from mains during
the update process.
Open the web interface of the SmartPanel:
·
Enter the IP address in the web browser
(e.g. 192.168.41.159).
In this example there is only one SmartPanel in
the network.
The web interface opens.
·
Click on the 'SELECT FW' button.
·
Navigate to the location of the firmware file
and select the desired one by clicking the
Open button.
22
figure 30: rebooting
figure 31: IP address of the
SmartPanel
figure 32: web interface of the SmartPanel
figure 33: select firmware
·
Click on the 'INSTALL' button.
figure 34: install
The selected firmware is transferred
into the SmartPanel. A bar graph
visualizes the update progress.
figure 35: install
The SmartPanel must be rebooted to
finish the update process.
·
Click on the 'Reboot' button if the
'Auto Reboot' function is disabled.
figure 36: reboot
The device is restarted. The connection
is interrupted during the restart.
figure 37: restarting device
If the connection is re-established after
the reboot, the new firmware version is
active.
figure 38: new firmware