Parts Identification; Assembly And Setup - Panasonic Technics SL-1600M Service Manual

Parts identification

Hinge
Pitch control knobs
Assembly and set-up
Apply two or three drops of oil to the motor shaft
using the furnished oil container. (See Fig.
Although the unit has been lubricated before shipping
from the factory, apply a few drops of oil to the
motor shaft for assurance. After that, application of
two or three drops of oil once every 2000 hours'
operation or so is sufficient.
much longer than that of the former type motors
(200 500 hours), so do not apply too much oil, nor
-
more frequently than necessary. Never use any other
type of oil.
1. Remove the cartrige.
2. Fix the tone arm to the arm rest.
3. Remove the turntable.
4. Turn the player set upside down with good care
not t o damage the acryl cover.
5. Take off 4 vis-screws from the back panel.
6. Place the player set face upward holding i t with
both hands so that the body is not separated from
the main body.
SL-1600
2)
The time interval is
.
www.vinylengine.com
Turntable base
from the panel cover.
(2) Draw out three connectors.
(3)
For separation of the body from the main
base, turn the cueing lever upward, move the
tone-arm in inboard direction, then lift up the
body.
Note:
The turntable horizontaliy to the panel face is
already adjusted before shipment.
If deviated, correct i t by means of the adjust
screws using a 5mm box spanner.
Turntable base
Fig. 1
Main base