General Information; Reading And Storing The User Manual; Explanation Of Symbols - Batavia Giraffe Air BT-TL008 Operating Instructions Manual

Telescopic ladder - 3,25 m
Hide thumbs Also See for Giraffe Air BT-TL008:
Table of Contents

Advertisement

Available languages

Available languages

.
English

General information

Reading and storing the user
manual
This user manual accom-
panies this aluminium tele-
scopic ladder 3.25 m
(hereinafter referred to as "ladder").
It contains important information
about safety and use.
Before using the ladder, read the
user manual carefully. This particu-
larly applies to the safety instruc-
tions. Failure to heed this user
manual may result in severe injury
or damage to the ladder.
The user manual is based on the
standards and rules in force in the
European Union. When abroad, you
must also observe country-specific
guidelines and laws.
Store the user manual for future
use. If you pass the ladder on to
third parties, please be absolutely
sure to include this user manual.

Explanation of symbols

The following symbols and signal
words are used in this user manual,
on the ladder or on the packaging.
WARNING!
This signal symbol/word designates
a hazard with moderate degree of
risk which may lead to death or
severe injury if not avoided.
18
7062696-Telescopic_Ladder-Ma-1611-17.indb 18
CAUTION!
This signal symbol/word designates
a hazard with low risk that, if not
avoided, may result in minor or
moderate injury.
NOTICE!
This signal word warns against
potential damages to property.
This symbol provides you
with additional useful infor-
mation regarding handling
or use.
TÜV Rheinland con-
firms that the tele-
scopic ladder meets
the relevant requirements of a safe
product.
Read and understand the
user manual before using
the ladder.
During deployment bear in
mind the necessary incli-
nation angle. The
inclination angle/propping angle of
the ladder must amount to approx.
75° (ratio 1 : 4).
Observe the maximum
load capacity of 150 kg.
Bear in mind that
the ladder over-
hang over the
contact point must amount to at
least 1 m.
14-12-16 11:21

Advertisement

Table of Contents
loading

Table of Contents