Summary of Contents for Barracuda Networks NG Firewall F200 / F201
Page 1
Barracuda NG Firewall F200 / F201 Revision A https://campus.barracuda.com/doc/43847020/ Opening your Barracuda Networks appliance or removing its warranty label unless instructed to do so by Barracuda Networks support will void your warranty and hardware support. Barracuda Networks Appliance Safety Instructions Always use the power supply shipped with the appliance.
The hardware specifications list was valid at the time this manual was published. The listed components are subject to change at any time, as Barracuda Networks may change hardware components due to technological advancements. Therefore, the list may not reflect the current hardware configuration of the Barracuda Networks NG Firewall or NG Control Center appliance it...
In order to establish a console connection to the appliance using a serial cable (Revision A: DB9, Revision B: RJ45), you need to configure the serial port on the terminal using the following parameters: Parameter Value Baud 19200 Bits Stop bit Parity None Barracuda NG Firewall F200 / F201 Revision A 3 / 5...
Page 4
Barracuda CloudGen Firewall Handshake None Barracuda NG Firewall F200 / F201 Revision A 4 / 5...
Page 5
Barracuda Networks Inc. All specifications are subject to change without notice. Barracuda Networks Inc. assumes no responsibility for any inaccuracies in this document. Barracuda Networks Inc. reserves the right to change, modify, transfer, or otherwise revise this publication without notice.