ASSEMBLY INSTRUCTION
Caution:
*Need at least 2 adults to complete this step.
*Before this step, please put all parts on a soft and clean surface to prevent any damage or scratch product finish.
4-1. Put Metal Cam (6) into hole on the Connect Bar (D), then assemble Connect Bar (D) to Left Side Panel (B).
4-2. Assemble Left Side Panel (B) to Desk Top (A) with Hex Bolts (1), Spring Washers (2) and Flat Washers (3) by Small
Hex Wrench (4).
4-3. Use Big Hex Wrench (8) to lock the Metal Cam (6) according to the direction of rotation as above shown.
Do not tighten any hex bolt in this step, as you might need to adjust the writing desk later.
Hardware and Tool Used
1
3
6
Hex Bolt x4
Flat Washer x4
Metal Cam x1
2
4
8
STEP 4
Spring Washer x4
Small Hex Wrench
x1
Big Hex Wrench
x1
7 of 11