AudioCodes Mediant 800 Series Hardware Installation Manual page 22

CHAPTER 5 Cabling the Device
Figure 5-2:
These ports support half- and full-duplex modes, auto-negotiation, and straight or crossover cable
detection.
Cable specifications:
■ Cable: Category 5e or Category 6 shielded twisted pair (STP) straight-through
■ Connector Type: RJ-45
■ Connector Pinouts:
Pin
1
2
3
6
4
5
7
8
Shield
➢
To connect the device to the LAN:
1. Connect the RJ-45 connector on one end of the Ethernet cable to one of the device's Ethernet
ports, labeled GE (for Gigabit Ethernet ports) and FE (for Fast Ethernet ports).
LAN Port-Pair Groups and Web Interface String Names
Table 5-1: RJ-45 Connector Pinouts for GbE/FE
Ethernet signal pair (10/100/1000Base-T)
Ethernet signal pair (10/100/1000Base-T)
Ethernet signal pair (1000Base-T)
Ethernet signal pair (1000Base-T)
Chassis ground
Figure 5-3: Connecting the LAN Ports
Mediant 800 Gateway & E-SBC | Hardware Installation Manual
Signal Name
- 17 -