CITROEN Berlingo Electric Handbook page 29

Hide thumbs Also See for Berlingo Electric:
Table of Contents

Advertisement

Charging the battery with a
battery charger
Do not charge the battery without
fi rst disconnecting the terminals
and removing the battery from the
front compartment.
Do not disconnect the
terminals when this indicator
warning lamp is on, nor when
the vehicle itself is on charge.
Before disconnection
Switch off the ignition and wait two
minutes before disconnecting the
battery.
After reconnection
After any reconnection of the battery,
switch on the ignition and wait
1 minute before starting, so as to
allow initialisation of the electronic
systems. However, if some minor
problems remain after carrying out this
operation, contact a franchised dealer
or a qualifi ed workshop. Remember
to enter the radio pre-sets yourself,
referring to the corresponding section
in the handbook.
-
Remove the battery fi xing 1 ,
-
lift the protective cover on the ( - )
terminal,
-
disconnect the cable from the ( - )
post
-
lift the protective cover on the ( + )
terminal 2 ,
-
slacken the nut 3 ,
-
disconnect the cable from the ( + )
post,
-
remove the battery,
-
charge the battery following the
instructions on use provided by
the manufacturer of the battery
charger,
-
reconnect the battery starting with
the cable on the ( + ) post.
Ensure that the battery posts and
terminals are clean. If they are
covered with sulphates (whitish or
greenish deposit), remove them and
clean them.

Advertisement

Table of Contents
loading

Table of Contents