Advertisement
•
Makes logic, calculation and control functions
possible for an EIB network
Option X9017 is a plug-in card for serial communication
on the EIB bus. This interface has no galvanic isolation
from the rest of the internal electronics.
The option occupies Port 2 or Port 3 in EXOflex, and
Port 3 in other controllers. The maximum cable length
is 3 meters. It is important that the cable is placed away
from power cables.
See the EIB manual for more information.
Regin product information
X9017
Option card, EIB
Communication card for EIB and KNX networks, for
internal mounting in an EXOflex house etc.
•
For applications where EP7408, EP8101 or EP8102
are installed
•
Suitable for controlling lighting etc. over EIB
The figure below illustrates the connection of an EIB bus
connector, BCU, to EP8101/EP8102. The DTR output on
EP8101/EP8102 cannot be controlled from software but
is internally connected to +12 V.
revision
08 2007
Advertisement
Table of Contents
Related Manuals for Regin X9017
Summary of Contents for Regin X9017
- Page 1 • Suitable for controlling lighting etc. over EIB Option X9017 is a plug-in card for serial communication The figure below illustrates the connection of an EIB bus on the EIB bus. This interface has no galvanic isolation connector, BCU, to EP8101/EP8102. The DTR output on from the rest of the internal electronics.
- Page 2 Regin product information Connections The RS232 Port The designations below follow the RS232 standard’s DTE terminology. Pin no Signal Function Direction Port 2 TxD2 Transmit data RxD2 Receive data RTS2 Request to send CTS2 Clear to send GND2 Signal Ground SEL2 Select RS232 interface.
- Page 3 Regin product information Connection of EP7408 with the EIB option X9017 on Port 3. Pin no Signal Detailed function Group function +24 V DC. Output for analog inputs AI and digital inputs DI. EMI ground This terminal is connected internally to the PIFA’s frame and to internal protective circuits.
- Page 4 Regin product information Connection of EP8101 with the EIB option X9017 on Port 3. Pin no Signal Detailed function Group function EMI ground This terminal is connected internally to the PIFA’s frame and to internal protective circuits. It should be connected to the ground rail with a separate, heavy gauge.
- Page 5 Regin product information Connection of EP8102 with the EIB option X9017 on Port 3. Pin no Signal Detailed function Group function EMI ground This terminal is connected internally to the PIFA’s frame and to internal protective circuits. It should be connected to the ground rail with a separate, heavy gauge.
Need help?
Do you have a question about the X9017 and is the answer not in the manual?
Questions and answers