Install The Magicfx® Stage Blower; Maintenance - Magicfx STAGE BLOWER User And Installation Manual

2.2 INSTALL THE MAGICFX® STAGE BLOWER
1. Place the machine in a suitable area and make sure it is built-in or placed in a stable way.
2. Adjust the angle towards the desired direction.
3. Connect the machine to a power supply.
CAUTION: Do not use a dimmer pack or similar device!
4. To start blowing:
Set the speed control button in the desired position (1, 2, 3, from slow to fast).
5. To stop blowing:
Set the speed control button in the OFF position (0).
6. Disconnect the machine from the power supply.
7. Remove the Stage Blower.
3

MAINTENANCE

CAUTION: Never carry out maintenance on a working/rotating Stage Blower! Always disconnect
the power supply before maintenance.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a qualified person once a year.
The following points have to be considered during the inspection:
1. All screws used for installing the machine or parts of the machine have to be tightly connected
and must not be corroded.
2. There may not be any deformations on housings, fixations and installation spots.
3. Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
4. The electric power supply cables must not show any damages or material fatigue.
The MAGICFX® STAGE BLOWER requires almost no maintenance. However, you should keep the unit
clean. Otherwise, the machine's performance will be significantly reduced. Do not immerse in
liquid. Do not use alcohol or solvents.
Please clean internal components once a year with a light brush and vacuum cleaner.
MAGICFX® STAGE BLOWER – User and Installation Manual 7