Changing The Tool; Mode Selector Switch - Bosch GBH 2-24 DS Manual

Changing the tool

The SDS-plus tool is designed to be freely movable. This causes
eccentricity when the appliance is off-load. However, the drill
automatically centres itself during operation. This does not affect drilling
precision.
Take care that the dust protection cap 1 is not damaged when changing
tools.
Inserting:
Clean and lightly oil the tool before inserting.
Insert the dust-free tool into the tool holder with twisting until it latches. The tool
locks itself.
Check the locking by pulling on the tool.
Removing:
Pull the locking sleeve 2 to the rear and hold while removing the tool.

Mode selector switch

Set the impact stop switch 7 to Drilling (only activate when the drill is
at a standstill).
Press the release button 6 on the mode selector switch 7 and move the button
to the desired position.
Drilling Hammer Drilling
Drill with cylindrial shaft
Steel, wood and plastic can be drilled with the ring gear chuck (accessory) and
the corresponding adapter (accessory).
Twist the mounted dust-free drill chuck into the tool-holding fixture and push in
until it engages. The chuck locks automatically. Pull on the drill chuck to check
that it is locked.
Set the impact stop switch 7 to Drilling (only activate when the drill is
at a standstill).
Chisel adjustment Chiseling
(Variolock) (Rotation OFF)
13