Programming With 'Videoplus - Philips VR676/05 Operating Instructions Manual

Programming with 'VIDEOPlus+'

All the information required for a programming is contained
encoded in the VIDEOPlus+ code.
1
Switch on the TV set.
2 TIMER k
Press the button on the remote control.
3
Please enter the VIDEOPlus+ code (up to 9 digits) printed
in your TV guide next to the start time of a TV pro-
gramme.
If you make a mistake, clear with the
VIDEOPLUS
53124----
ONCE
------------------------
D/WgSELECT
0-9
4
If you want to programme at daily or weekly intervals,
SELECT
press the button until 'D-DAILY' (daily intervals)
or 'W-WEEKLY' (weekly intervals) appears on the TV
screen. The 'daily intervals' function can only be used for
recordings to be made from Mondays to Fridays inclu-
sive.
5
Confirm the entries with the
data appear on the TV screen.
Note: If you use VIDEOPlus+ for the first time for this TV
channel, the 'SELECT PROG' line appears when you
confirm the VIDEOPlus+ code. Select and confirm the
programme number for the TV programme required.
* Switch 'PDC' or 'VPS' (V/P) on or off with the
SELECT
button.
* If you wish to set a later end time for a recording,
P q
press the button at step
P q
the button you add 15 minutes to the time.
* If e.g.: '20:00' appears in the display, please set the
clock.
CLEAR (CL)
button.
gCL
CLEAR
OK
OK
button. The resultant
5 . With each press on
6
OK
Finally, press the
complete.
The data has been stored in a TIMER block.
7
Make sure that a cassette without erase protection has
been loaded. Switch to standby with the
button.
A programmed recording will only function when the
video recorder is switched to standby with the
STANDBY m
button.
Note:
* VIDEOPlus+ Aerial-code numbers: With this set,
VIDEOPlus+ aerial-code numbers will be allocated auto-
matically.
button. Programming is now
STANDBY m
9