Taking Photos; Retrieving Recordings - Panta Pocket Cam M18205 Instructions For Use Manual

switched on, but will stop recording.
3. To turn the Panta® Pocket Cam off, simply press and hold the on/off button for 4
seconds, or until the LED light turns off. Night Mode – When the Panta® Pocket
Cam is turned on and motion is detected, it will continue to record - even in
darkness. Infra-red lights around the camera's lens (Figure H) will be activated, but
they are not visibly lit.

TAKING PHOTOS

1. To switch from Video to Photo mode, simply press and hold the on/off button down
for 2 seconds. LED light will illuminate solid green, indicating photo mode has been
activated. To take a photo, briefly press the on/off button once. The LED light will
flash once after each click, indicating that a photo has been taken.
2. To switch back to video mode, press and hold the on/off button for 2 seconds. LED
light will turn solid red, indicating photo mode has been deactivated and camera is
back in video mode.
Video Format
Video Coding
Video Resolution Ratio
Video Frame Rate
Player
Support System
Image Format

RETRIEVING RECORDINGS

1. Remove the microSD card from the Panta® Pocket Cam by gently pushing the
microSD card inward to release, then gently pulling the card out of the slot. Insert
the microSD card into an SD card adapter (not provided) (Figure I). Once the
microSD card is inserted into the adapter, plug the adapter into the SD card port of
your computer/laptop.
NOTE: The SD card port can be located on either the left or right side of your
computer/laptop.
2. If you do NOT have a microSD card adapter, or your computer/laptop does NOT have
M18205_PantaPocketCam_Manual_A5_20181031_KS.indd 12
AVI Image Proportion
MJPG Battery Capacity
720p Operation Time
720 at 30 fps
Charging Voltage
(default)
Pot Player /
Interface Type
Windows Player
Microsoft
Storage Support
Windows XP/7/8
JPG Battery Type
12
1.3 M
200mAh
Up to 45
Minutes
5 V
Micro-USB
Yes
Lithium Battery
29.11.18 11:00