Remote Control Unit - THOMSON MIC301BT Operating Instructions Manual

REMOTE CONTROL UNIT

1. Remove the battery cover from the back of the remote control.
2. Insert 2 AAA batteries. Check the polarity (+ and – at ends of the battery) and follow the instructions
on the diagram near the battery compartment. Close the compartment door.
NOTE: Please make sure you properly dispose of batteries (see your local regulations).
3. Replace the battery cover.
BATTERY REPLACEMENT
When the battery runs low, the distance at which the remote control will operate is greatly reduced and
you will need to replace the battery.
1. To use the remote control unit, point it at the IR sensor (10) and press the button gently but firmly.
Since the remote control range is reduced when the unit is used at an angle, try to aim it directly
at the remote sensor.
2. Do not expose the remote sensor to strong light (direct sunshine or artificial light) and make sure
that there are no obstacles between the remote sensor and the remote control.
SPEAKER
Connect a pair of speakers to the unit via the SPEAKER output L, R sockets (16) on the rear panel.
[1] Power On / Off
[2] CD Open / Close
[3] Function: BT (Bluetooth) / Audio In / CD Disc /
USB / TUNER
[4] Folder + / Preset +
[5] Skip BACK
[6] Bluetooth Pair
[7] FM Scan
[8] Repeat (Repeat one / Folder / All)
[9] Random
[10] MUTE
[11] EQ (Equalizer: Rock / POP / Classic / JAZZ / Off)
[12] Play / Pause
[13] Skip FORWARD
[14] Folder – / Preset –
[15] Stop
[16] Memory
[17] Volume +
[18] PROGRAM
[19] Volume –
[20] Clock Set
[21] + 10 (skip 10 songs)
- EN 3 -