Related Manuals for Onyx Full Showers with Return
Summary of Contents for Onyx Full Showers with Return
- Page 1 202 Anderson Ave., Belvue, KS 66407 Phone: 800-669-9867 Fax: 800-393-6699 800-643-1514 www.onyxcollection.com www.alumaxbath.com Semi-Frameless Hinged Door With Panel And Return Full Showers with Return 393CV-1217...
- Page 2 Page 2 of 8...
- Page 3 Remove wall jambs and also the curb track. WALL JAMB Drill 5/16” holes through the ONYX wall panels or tile and insert 1/4” anchors ( C ) (if there is wood backing in the wall, no anchors are necessary). CURB Clean the debris off of the threshold.
- Page 4 Apply a bead of silicone along the inside both of #8 x 2” the pencil lines made on step 2. Silicone both ends of the curb (A) (be very generous SILICONE with the silicone at the ends of the track). Carefully place curb down onto the threshold so it is resting on the silicone between the pencil lines.
- Page 5 Press header (H) over the wall jambs (B), the 180 ° post, (G) and the 90° post (Y). Using the holes in the header (H) and curb (A) as a guide, drill four 1/8” holes into the wall jambs (B), be careful not to drill into the glass.
- Page 6 Remove tape and plumb door assembly laterally, then drill two 1/8” holes about 1/4” vertically from the header (H) and curb (A). Then screw the hinge jamb into place using two #6 x 3/8” truss head screws. Slide snap-in fillers (L) over to the hinge jamb so that it is flush against it.
- Page 7 Loosen set screws using a small allen wrench (BE CAREFUL NOT TO UNSCREW ALL THE WAY!). Separate the handle and unscrew the cone head screws. Place one plastic washer and one plastic bushing onto the cone head screw, slide screw through the top hole in the glass door, next place one plastic washer onto the screw then attach handle (do not tighten all the way).
- Page 8 CURB SETTING BLOCK Using Onyx Adhesive / Sealer, caulk the entire exterior and interior of the shower door. Also, fill the small gaps at the corner of the vinyls that hold the glass side panels. It is recommended to wait 24 hour be for using the shower so that the caulking can cure.
Need help?
Do you have a question about the Full Showers with Return and is the answer not in the manual?
Questions and answers