Iceking CF300W Installation And Operating Manual page 6

3. The appliance should be located on a smooth surface.
4. It is forbidden to use the refrigerator outdoors.
5. Protection from moisture. Do not locate the freezer in moist space to avoid the metal
parts rusty. And do not spray water to the freezer, otherwise it will weaken the
insulation and causes current leakage.
6. Refer to "Cleaning and Care" section to prepare your appliance for use.
7.
If the freezer is installed in unheated areas, garages etc., in cold weather
condensation may form on the outer surfaces. This is quite normal and is not a fault.
Remove the condensation by wiping with a dry cloth.
STARTING
Final Check
Before you starting to use the freezer, please check that:
1. The interior is dry and air can circulate freely at the rear.
2. Clean the interior as recommended under "CLEANING AND CARE".
3. Insert the plug into the wall socket and switch on the electricity supply，then the
Red light is on. Avoid accidental disconnection by taping over the switch. Green
light will glow and the compressor will start running (see Freezer Operation page
7).
4. You will hear a noise as the compressor starts up. The liquid and gases sealed
within the refrigeration system may also give rise to noise, whether the
compressor is running or not which is quite normal.
5. If you going to store already frozen food open the freezer lid and check that the
freezer has reached the correct temperature. Then you can put in your already
frozen food. (See Storing Frozen Food page 8).
6. Do not load the appliance immediately after it is switched on. Wait until the correct
storage temperature has been reached. We recommend that you check the
temperature with an accurate thermometer (see Freezer Operation page 7).