Gemini GAF1500E Manual page 5

(Twinkling when the timer is running)
(Rotating when power on)
Pre-heat the appliance for 5 minutes if the appliance turns cold
Note: You can also pre-heat the appliance without any ingredients inside. In that case, press the
"Pre-heat" program on the control panel and then press the "Start
frying basket with food, choose the correct cooking program and start the program by pressing the
"Start " button. The heating element and fan motor icons will light up to show the cooking status
and the time will count down on LCD screen.
7. Some ingredients require to shake halfway during the operation (see section 'K' settings).
Pull the frying basket out of the appliance using the handle and shake it. Then slide the frying
basket back into the fryer. (fig.8)
Tip: If you set the timer to half of the preparation time, you have to shake the ingredients when
you hear the timer bell rings. However, it means that you have to set the timer again to the
remained preparation time after shaking.
8. When you hear the timer alert, the operation is completed. Pull the frying basket out of the
appliance and place it on the heat-resistant holder. (fig 9)
Note: You can also switch off the appliance manually by pressing the "Cancel
appliance will be stopped completely after 20 seconds.
9. Check if the ingredients are ready.
If the menu are not fully-cooked yet, simply slide the frying basket back into the appliance
and choose the program again but manually adjust the cooking time by reducing a few minutes.
10. Empty the frying basket into a bowl or onto a plate. (fig.10)
Tip: To remove large or fragile ingredients, lift the ingredients out of the frying basket by a pair of tongs.
11. When one batch of ingredients is ready, the fryer is instantly ready for preparing another batch.
*After the completion of each cooking program (with a "beep" tone alert) or press the "Start
"Cancel " buttons during cooking process, the appliance will be shut down automatically after 20 seconds*
Note:
If you want to stop the program for a while and continue later, you can press the "Start
to pause the process. And then press the "Start
If you press the "Start / Pause " button during cooking and then open the door, the operation will
be paused. When you close the door again, the program will stop and reset to the basic setting.
3
7
Heating element icon
Fan motor icon
/ Pause " button again to continue the program.
4
8
5
Control Panel
" button to start. Then fill the
5 6
9 10
" button. The
/ Pause " or
/ Pause " button