Operation - Lenze AC Tech SMVector RS-485 LECOM Communication Module Reference Manual

1.5

Operation

Systems including controllers must be equipped with additional monitoring and protection devices according to the
corresponding standards (e.g. technical equipment, regulations for prevention of accidents, etc.). You are allowed to
adapt the controller to your application as described in the documentation.
DANGER!
• After the controller has been disconnected from the supply voltage, do not touch the live components
and power connection until the capacitors have discharged. Please observe the corresponding
notes on the controller.
• Do not continuously cycle input power to the controller more than once every three minutes.
• Close all protective covers and doors during operation.
WARNING!
Network control permits automatic starting and stopping of the inverter drive. The system design must
incorporate adequate protection to prevent personnel from accessing moving equipment while power
is applied to the drive system.
Pictograph
Safety Information
Table 1: Pictographs used in these instructions
Signal Word Meaning
DANGER! Warning of Hazardous
Electrical Voltage.
WARNING!
Impending or possible
danger for persons
STOP!
Possible damage to
equipment
NOTE
Useful tip: If observed, it will
make using the drive easier
CMVLC401A
Consequences if Ignored
Reference to an imminent danger that may
result in death or serious personal injury if
the corresponding measures are not taken.
Death or injury
Damage to drive system or its
surroundings
3