Rs485 Lecom-Specific Parameters - Lenze AC Tech SMVector RS-485 LECOM Communication Module Reference Manual

4.2

RS485 LECOM-Specific Parameters

The parameters listed in Table 6 are only present in the drive if there is an RS485 communication module installed,
P400 = 7 and the module is online (P402 = 3).
Code
No. Name
P410 Network address
P411 Network
Baud Rate
P420 Network Control
Level
P424 Network Powerup
Start Status
Network Message
P425
time-out
P426 Network Message
time-out action
P427 Valid Network
messages
Received
Communication
P494
Module software
version
Internal Code
P495
Commissioning
Table 6: RS485 LECOM-Specific Parameters
Possible Settings
Default Selection
1 1
0 0 9600 bps
1 4800 bps
2 2400 bps
3 1200 bps
4 19200 bps
0 0 Monitor Only
1 Parameter Programming
2 Programming and Setpoint Control
3 Full Control
4 Full Control (Special)
0 0 Quick Stop
1 Controller Inhibit
50 0 {ms}
0 0 No action
1 Controller Inhibit
2 Quick Stop
3 Trip Fault, F.nF1
0 0 {messages}
CMVLC401A
99 The values 00, 10, 20, 30 ... 90 must not
be used since they are reserved for group
addressing (see section 6.4).
P420 =2, 3: setpoint control using code
number C0046 or C1061.
P420 = 3, 4: drive control using code
numbers C0040 and/or C0135
P420 = 4: setting C0140 = 0 results in
Quick Stop
Stop commands (QUICK STOP, INHIBIT)
will always be accepted.
65000
9999 • Read-only
• When number of messages exceed
9999, counter resets and resumes
counting from 0.
• Read only
• Format: x.yz
• Read only
• Alternating Display: xxx-; -yy
IMPORTANT
9