Whirlpool ADG 195 Instructions For Use Manual page 11

1. To open the dispenser, turn the cap to the "open" (left) arrow and lift it out.
2. Pour the rinse aid into the dispenser, being careful not to overfill.
3. Replace the cap by inserting it aligned with "open" arrow and turning it to the closed (right) arrow.
NOTE
Clean up any rinse aid spilled while during filling with an absorbent cloth to avoid excessive foaming during
the next wash. Don't forget to replace the cap before you close dishwasher door.
Adjusting Rinse Aid Dispenser
Adjust lever
The rinse aid dispenser has six or four settings. Always start
(Rinse)
with the dispenser set on "4". If spots and poor drying are a
problem, increase the amount of rinse aid dispensed by
removing the dispenser lid and rotating the dial to "5". If the
dishes still are not drying properly or are show spots, adjust
the dial to the next higher lever until your dishes are spot-free.
The recommended setting is "4". (Factory value is "4".)
NOTE
Increase the dose if there are drops of water or lime spots on
the dishes after washing.
Reduce it if there are sticky whitish stains on your dishes or a bluish film on glassware or knife blades.
10