Dishwasher Installation Steps - Whirlpool ADG 195 Instructions For Use Manual

Dishwasher installation steps

1. Install the furniture door to the outer door of the dishwasher using the brackets provided. Refer to the
template for positioning of the brackets.
2. Adjust the tension of the door springs by using an Allen key turning in a clockwise motion to tighten
the left and right door springs. Failure to do this could cause damage to your dishwasher (illustration 2).
3. Connect the inlet hose to the cold water supply.
4. Connect the drain hose. Refer to diagram. (Fig. 6).
5. Connect the power cord.
6. Affix the condensation strip under the work surface of cabinet. Please ensure the condensation strip is
flush with edge of work surface.
7. Place the dishwasher into position. (Illustration 4)
8. Level the dishwasher. The rear food can be adjusted from the front of the dishwasher by turning the
Allen screw in the middle of the base of dishwasher use an Allen key (Illustration 5A). To adjust the
front feet, use a flat screw driver and turn the front feet until the dishwasher is level (Illustration 5B).
9. The dishwasher must be secured in place. There are two ways to do this:
A. Normal work surface: Put the installation hook into the slot of the side plane and secure it to the
work surface with the wood screws (Illustration 6).
B. Marble or granite work top:Fix the side with Screw. (Illustration 7).
Figure 7
Condensation strip
25