Troubleshooting - Philips CED229/55 User Manual

8 Troubleshooting

Caution
•
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
system, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/support). When you contact Philips,
make sure that your system is nearby and the
model number and serial number are available.
No power
• Car engine has not been started. Start
the car engine.
• Connections is incorrect.
• Fuse has been damaged. Replace fuse.
No sound
• Volume is too low. Adjust volume.
• Speaker connections is incorrect.
No response to the remote control
• Ensure that the path between the
remote control and the unit iis clear from
obstacles.
• From a close distance, point the remote
control directly at the unit.
• Replace the remote control battery.
• The function does not work. Refer to the
instructions.
Disc does not play
• Disc is upside down. Ensure the printed
side is upwards.
• Disc is dirty. Clean the disc with a
clean, soft, lint-free cloth. Wipe the disc
outwards from the center.
• Disc is defective. Try another disc.
• Imcompatible disc is used. Try another disc.
• Disc rating exceeds the restrict setting.
Change the rating settings to lower one.
• Disc region code is not compatible with
the unit. Use disc with proper region code.
20 EN
ce229 um 55.indd 20 ce229 um 55.indd 20 ce229 um 55.indd 20
Disc is blocked in the disc compartment
• Press and hold until the disc comes out.
No image
• Parking brake wire connection is
incorrect. Check the parking wiring.
Image flashes or distorted
• Video DVD settings do not match with
the DVD. Adjust video DVD settings.
• Video connection is improper. Check the
connections.
Noise in broadcasts.
• Signals are too weak. Select other
stations with stronger signals.
• Check the connection of the car antenna.
• Change broadcast from stereo to mono.
Preset stations lost.
• Battery cable is not connected correctly.
Connect the battery cable to the terminal
that is always live.
Fuse is broken
• The Fuse type is incorrect. Replace it with
a 15A fuse.
• Speaker wire or power wire is grounded.
Check the connections.
Display show ERR-12
• USB/SD/MMC data error. Check the USB
device or SD/MMC card.
25/05/2011 18:00:08 25/05/2011 18:00:08 24/05/2011 21:46:08 ce22