Get Started; Install The Car Audio; Attach The Front Panel; Install Remote Control Battery - Philips CEM3000/00 User Manual

3 Get started

Caution
•
Use the controls only as stated in this user
manual.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of your apparatus. The
model number and serial number are on the
bottom of your apparatus. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________

Install the car audio

Please refer to the "Installation guide" in Quick
start guide.

Attach the front panel

1
Attach the trim plate.
2
Insert the right side of the panel in the
chassis until it is correctly engaged.
3
Press the left side of the panel until the
mechanism locks it into place.
10 EN

Install remote control battery

Caution
• Risk of explosion! Keep batteries away from
heat, sunshine or fi re. Never discard batteries
in fi re.
•
Risk of decreased battery life! Never mix
different brands or types of batteries.
•
Risk of product damage! When the remote
control is not used for long periods, remove
the batteries.
•
Perchlorate Material - special handling may
apply. See www.dtsc.ca.gov/hazardouswaste/
perchlorate.
For fi rst-time use:
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2025 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.