Reversibility Of The Freezer Door; Ventilation Requirements; Installing The Appliance - Zanussi ZBA30455SA User Manual

3. Remove the door.
4. Loosen the lower pin.
5. Install the lower pin on the opposite side.

Ventilation requirements

The airflow behind the appliance must be
sufficient.
5 cm
2
min. 200cm
min.
200cm 2
26
180˚
6. Install the door.
7. Tighten the spacer and tighten the upper
pin.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes
correctly.
If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the
gasket. In case you do not want to
carry out the above mentioned
operations, contact the nearest After
Sales Service Force. The After Sales
Service specialist will carry out the
reversibility of the doors at your cost.

Reversibility of the freezer door

Installing the appliance

Make sure that the mains cable can move freely.
1. If necessary cut the adhesive sealing strip
and then apply it to the appliance as shown
in figure.
2. Drill the unit using a Ø 2.5 mm drill (10 mm
max. penetration), Fix the square fitting to
the appliance.
www.zanussi.com