Furniture Door - Miele KS 37472 iD Operating And Installation Instructions

Furniture door

Horizontal and vertical gaps
The thickness and edge radius of the
furniture door and the gap that runs
around the door, vertically and
horizontally, are specified depending on
the style of kitchen furniture.
It is essential to pay attention to the
following:
– Horizontal gap
The gap between the furniture door and
the kitchen unit door above or below,
respectively, must be at least 3 mm.
– Vertical gap
If the gap between the appliance
furniture door and the adjoining
housing unit door or wall on the
hinged side is too small, the
appliance door could collide with the
adjoining housing unit door or wall
when opened.
It may be necessary to adjust the
size of this gap to suit the thickness
and edge radius of the appliance
furniture door.
This must be taken into consideration
when planning your kitchen and when
replacing an old appliance with a new
one to ensure the installation conditions
required are met.
Appliance
furniture
door
thickness
A [mm]
R 0
≥16 - 19
20 5
21 5.5
22 6.5
Adjoining kitchen furniture front
A = Furniture front thickness
B = Edge radius
X = Gap
Adjoining side wall
A = Furniture front thickness
B = Edge radius
X = Gap
Useful tip: Fit a spacer between the
housing unit body and the side wall.
This way you will get a sufficiently wide
gap.
Installation
Gap X [mm]
for different
edge radii B
R 1,2 R 2 R 3
min. 3
4 4 3.5
5 4.5 4
6 5.5 5
65