Power Climber Titan Series Operating Instructions Manual

OPERATING
INSTRUCTIONS
Models: Single phase: TITAN 501 and TITAN 651 hoist with Central Control box
Three phase: TITAN 503 and TITAN 653 hoist with Central Control box
Conform to EN 1808 (1999) and
 All persons operating this equipment must read and completely understand this
manual.
 All persons must be thoroughly trained in the use of the equipment, it's operational
and safety features, and they must also be capable of carrying out the daily
checklist.
 Only authorized and physically fit persons shall operate the equipment.
 Any operation in violation of these instructions is at the operator's own risk and
may result in serious injuries.
 Keep this manual with the hoist at all times.
 Only use spare parts and steel wire rope from POWER CLIMBER,

It is not allowed to put the machinery into service until the machinery into which it
is incorporated or of which it is to be a component, has been found and declared
to be in conformity with the provisions of Directive 98/37/EC and with national
implementing regulation.
 On platforms with only ONE hoist on ONE walk-through stirrup, an Overspeed
safety device is compulsory, in addition to the standard slack rope safety device.
Manufacturer: Power Climber b.v.b.a, Satenrozen 7, B-2550 Kontich BELGIUM
Reference: 38740-E
Tel. +32-3-451 05 00
This document and all copies are the property of Power Climber BVBA. All dimensions and data are indicative only.
WARNING:
Issue date: 24-Aug-2015
E-mail: Info@PowerClimber.be
Website: www.PowerClimber.be
The user must ensure that the equipment complies with local rules and regulations.
HOIST
Machine Directive 98/37 EC
Revision: D Page 1 of 16
Fax +32-3-451 05 01