IBM WorkPad Handbook page 35

To use the Graffiti menu commands, draw the Command stroke
followed by the corresponding command letter. When you draw the
Command stroke, the Command symbol appears just above the
Graffiti writing area to indicate that you are in Command mode.
Command
For example, to activate the Select All command in the previous
diagram, draw the Command stroke, followed by the letter "s."
Note: You do not have to tap the
you use the Graffiti menu commands. However, since the
Command mode is active for approximately two seconds, you
must write the letter character immediately to activate the
menu command.
Edit Menu Commands
The Edit menu is available with any screen where you enter or edit
text. In general, the Edit Menu commands available in the Edit menu
apply to text that you select in an application.
To select text in an application:
1. Tap the beginning of the text that you want to select.
2. Drag the stylus over the text to highlight it (in black).
Note: You can drag across the text to select additional words, or
drag down to select a group of lines.
Chapter 2
icon or access the menus when
Page 31