MATE ULTRA TEC Installation / Length Adjustment page 2

Mate Precision Tooling • 1295 Lund Boulevard • Anoka, Minnesota 55303 USA • Phone 763.421.0230 • 800.328.4492 • Fax 763.421.0285 • 800.541.0285
The Mate Logo is a registered trademark of Mate Precision Tooling Inc.
©2010 Mate Precision Tooling Inc.
Installation / Length Adjustment
ULTRA TEC
ATTACH  TO ...
SELECT ANGLE SETTING...
NOTE: ROUNDS ONLY CANISTER
INSERT  TO 
PARTIALLY INTO . DO
NOT SNAP TOGETHER...
INSERT  TO  .
LINE UP  WITH 
AND SNAP
TOGETHER...
®
and ULTRA ABS
Note: assembly, disassembly
and length adjustment are the
same as shown when using
Heavy Duty canisters.
®
1/2" A Station
PUSHING UP
LOCK BUTTON
ENABLING
THE
CANISTER
TO ROTATE...
ADJUST PUNCH
LENGTH...
While pushing up lock button to
disengage pin, rotate canister and
set punch face flush with stripper.
Turn canister eight 'clicks' clock-
wise to retract punch by .048(1.22),
providing proper stripper lead. Each
'click' equals .006(.15) length
adjustment.
TURN KNURLED PORTION OF
CANISTER UNTIL PIN UNTIL IT
LOCKS IN PLACE...
PULL ASSEMBLY
APART...
Dimensions in Inches(millimeters) mate.com