MATE ULTRA TEC Installation / Length Adjustment

Mate Precision Tooling • 1295 Lund Boulevard • Anoka, Minnesota 55303 USA • Phone 763.421.0230 • 800.328.4492 • Fax 763.421.0285 • 800.541.0285
The Mate Logo is a registered trademark of Mate Precision Tooling Inc.
Ultra TEC and Ultra ABS are registered trademarks of Mate Precision Tooling Inc.
Installation / Length Adjustment
ULTRA TEC
ATTACH  TO ...
SELECT ANGLE SETTING...
NOTE: ROUNDS ONLY CANISTER
INSERT  TO 
PARTIALLY INTO . DO
NOT SNAP TOGETHER...
INSERT  TO . LINE
UP  WITH  AND SNAP
TOGETHER...
PUSHING DOWN
LOCK BUTTON
WILL ALLOW
THE CANISTER
TO ROTATE...
®
and ULTRA ABS
®
1-1/4"B Station
ADJUST PUNCH LENGTH...
While pushing up lock button to
disengage pin, rotate canister and
set punch face flush with stripper.
Turn canister six 'clicks' clockwise
to retract punch by .048(1.22),
providing proper stripper lead.
Each 'click' equals .008(.020)
length adjustment.
ALIGN CANISTER...
Turn canister assembly until index mark is
aligned with the push button on the punch
guide.
DEPRESS BUTTONS AND PULL
ASSEMBLY APART...
HINT: The best way to
overcome button spring
pressure when disassembling is
to fully depress your index finger
button and then your thumb
button. Following this sequence
will make disassembly faster
and easier.
Dimensions in Inches(millimeters) mate.com
LIT00055 Rev F