Table of Contents
Advertisement
In this hookup guide, we'll figure out how to pull values from our fingers as well as calibrate the sensor for our
range of motion. We'll also cover recommended placement and installation to implement these into gloves.
Required Materials
To get started, you'll need a microcontroller to, well, control everything.
SparkFun RedBoard - Programmed with
Arduino
DEV-13975
Raspberry Pi 3
DEV-13825
Now to get into the Qwiic ecosystem, the key will be one of the following Qwiic shields to match your preference of
microcontroller:
SparkFun ESP32 Thing
DEV-13907
Particle Photon (Headers)
WRL-13774
Advertisement
Table of Contents
Need help?
Do you have a question about the Qwiic Flex Glove Controller SEN-14666 and is the answer not in the manual?
Questions and answers