Cable Innovations DLPS-15D Installation And Information Sheet

Advertisement

GENERAL INFORMATION:

1. This surge protector is for outdoor use.
2. The DLPS-15D is to be used with 75 ohm coaxial cable such as Series 59 and Series 6.
3. This is a dual directional protector, so either connector can be the service port and the other
connector would be the customer port.
4. DLPS-15D conforms to surge fusing guidelines outlined under UL-497C and ANSI/NFP70
National Electrical Code, Article 830 and is rated as a low power device as defined in Table
830-4.
5. The DC breakdown rating is 135 volts.
6. The normal operating parameters of the DLPS-15D are as follows:

LIMITED WARRANTY

Cable Innovations, Inc warrants its products to be free from defects in material and workmanship for a period of two (2) years. If a
product proves to be defective in material or workmanship during the warranty period, Cable Innovations, Inc will, at its sole option,
repair or replace the product. Please call 1-800-952-5146 8:00 AM to 5:00 PM EST Monday thru Friday for warranty information.
There are no warranties, expressed or implied, which extends beyond the description contained herein.
DWG# 1015D000 REV C
INSTALLATION AND INFORMATION
SHEET FOR DLPS-15D
Operating voltage: 60 and 90 volts
current: less than 1 Amp
wattage: 90 watts
Cable Innovations,Inc.
4665 Hwy 332 Suite C
Hoschton,GA 30548
770-962-5146
www.Cableinnovations.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DLPS-15D and is the answer not in the manual?

Questions and answers

Summary of Contents for Cable Innovations DLPS-15D

  • Page 1 LIMITED WARRANTY Cable Innovations, Inc warrants its products to be free from defects in material and workmanship for a period of two (2) years. If a product proves to be defective in material or workmanship during the warranty period, Cable Innovations, Inc will, at its sole option, repair or replace the product.
  • Page 2 3. Connect the cable to the DLPS-15D making sure to have drip loops, see figure 1. * Existing Installation: 1. Remove the cables from the grounding block and remove the grounding block from the installation.

Table of Contents