Table of Contents
Advertisement
3.3.4 A TYPICAL SINGLE-PORT TRANSMITTER–RECEIVER APPLICATION
Figure 3-9 shows a typical application in which the single-unit transmitter
is connected over CAT5 to a single-unit receiver.
Figure 3-7. Transmitter to receiver connections.
CHAPTER 3: Setup and Installation
CAT5 MULTI VIDEO SYSTEM.
4.1. Common Problems
In most cases, nearly every issue with the CAT5 Multi
resolved by checking the CAT5 termination and making sure that it's pinned to the
TIA/EIA 568B wiring specification. However, there may be other problems that
cause the system to not perform as it's designed. Below are solutions to the most
common installation errors.
Problem:
No video signal at the transmitter local port or at the receiver.
Solution:
• Check that both units are powered.
• Make sure the CAT5 cable is terminated correctly per the
TIA/EIA 568B wiring specification.
• Is the display device powered on and functioning?
In some cases, the video termination may be mismatched. The
transmitters and receivers ship with 75-ohm termination as the
default. To disable termination, see Appendix B.
Problem:
Video signal is poor.
Solution:
• Have all receiver settings been finished (see sections 3.3).
• Check all cable connections.
• The video signal's refresh rate may be set too high. Reset to a
lower refresh rate in your monitor-configuration menu.
• There may be a delay skew issue. Call Technical Support.
Problem:
Audio is poor.
Solution:
• Powered speakers are required. Make sure speaker power is
ON.
• Check input source levels from the source device. Make sure
the audio source is not overdriven or underdriven.
Problem:
Serial communication doesn't work correctly.
Solution:
• Are the serial devices connected properly? Are the serial
parameters correct for source/destination devices?
• Are the serial cables terminated correctly? If a null-modem
cable is used, it must be placed at the receiver end.
• When using daisy chain receivers, the serial signal is
a unidirectionally broadcast mode only. In this mode, all other
CAT5 Multi
type. For assistance, contact Technical Support.
• The last device in a daisychain configuration must
be a standard receiver unit with a terminated serial board.
9
10
4. Troubleshooting
Video
System devices must be the simplex serial
Video
System can be
Advertisement
Table of Contents
