Table of Contents
Advertisement
5. Plug the connector of the power supply into the back of the charging base, or plug it into the bottom
end of the Light itself, as shown in Figure 4. Plug the other end of the power supply into the
appropriate electrical outlet. As mentioned above, wait for at least 6 hours to completely charge the
light before the first use.
NOTE: Verify the line plug of the power supply plug is properly rated for your facility, and that all
connections comply with safe practices and all local requirements. Always use unit in conjunction with
a properly grounded outlet.
6.2 Keypad and modes
There are 2 buttons on the key pad for the mode/timer selection, and the on/off button. (Fig. 5) The
on/off button is used to activate and deactivate the light. Push once to turn on the light and push it
again if you need to turn it off at any time during the curing cycle.
There are 2 different modes to select from based on the procedure and the requirement. (Fig. 6)
- Select the exposure time by pressing the mode button briefly.
- If the mode/timer button is kept depressed, it will switch to another mode.
- While exposure is ongoing, the button for selection of the exposure time is inactive.
Figure 4
Mode / Time selecting button
Figure 5
8
On/off button
S-19-01-1125-UV101 V1.3
Advertisement
Table of Contents
