Advertisement
4. Use of the payment terminal
Turning on and off
When the power supply is connected, the payment terminal will start automatically. If the power supply has
been removed, the terminal can be started by pressing the green 'OK' button for a few seconds. The
terminal can only be switched off when it is disconnected from the power supply. Has the power been cut
off? You can switch off the terminal by pressing the yellow 'CLR' button at the same time as the point '.'.
Doing a transaction
Enter the desired amount. Press the green button to start the payment. If an incorrect amount has been
entered, this can be corrected by pressing the yellow button. You can stop the transaction by pressing the red
button.
Changing the paper roll
When the paper roll has run out, it can easily be replaced.
1.
Above the screen is the compartment where the pin roll is located. Open it by pulling
the cover towards you. See figure 1.
Figure 1.
2.
Remove the empty roll and insert a new paper roll. Place the paper roll with the beginning of
the roll facing up as shown in the image.
3.
Grab some of the paper and close the cover again.
4.
In the lower left corner is the 'F' button that allows the terminal to print out a piece of paper.
Press and hold this button to test whether the terminal is unrolling the paper roll correctly.
5. Payment methods
You received a sticker with payment logo's together with your payment terminal.
Cut out the logo's of the payment methods you offer to your customers. Please place this
sticker in a place that is clearly visible to your customers.
For more questions go to help.emspay.eu or call: 0800-3678324
Figure 2.
Any transaction - any way EMSpay.nl
Advertisement
