Intended Use - DeWalt DCF815 Original Instructions Manual

English
Only for indoor use.
Discard the battery pack with due care for
the environment.
Charge D WALT battery packs only with designated
e
D WALT chargers. Charging battery packs other
e
than the designated D
D WALT charger may make them burst or lead to
e
other dangerous situations.
Do not incinerate the battery pack.
Package Contents
The package contains:
1 Cordless impact driver or impact wrench
1 Charger
2 Battery packs
1 Impact rated screwdriver bit (DCF815)
1 Kitbox
1 Instruction manual
• Check for damage to the tool, parts or accessories which may
have occurred during transport.
• Take the time to thoroughly read and understand this manual
prior to operation.
Description (Fig. A)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Trigger switch
1
Forward/reverse button
2
Chuck collar (DCF815)
3
6.35 mm hex quick-release chuck (DCF815)
4
Battery release button
5
Battery pack
6
Worklight
7
Main handle
8
Hog ring (DCF813)
9

Intended Use

The impact driver and impact wrench are designed for
professional impact fastening applications. The impact function
makes this tool particularly useful for driving fasteners in wood,
metal and concrete.
DO nOT use under wet conditions or in the presence of
flammable liquids or gases.
This impact driver and impact wrench are professional
power tools.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
Young children and the infirm. This appliance is not
•
intended for use by young children or infirm persons
without supervision.
8
WALT batteries with a
e
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the battery pack voltage corresponds to the
voltage on the rating plate. Also make sure that the voltage of
your charger corresponds to that of your mains.
Your D WALT charger is double insulated in
e
accordance with IEC60335; therefore no earth wire
is required.
If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the D
service organisation.
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for
the power input of your charger (see Technical Data). The
minimum conductor size is 1 mm
is 30 m.
When using a cable reel, always unwind the cable completely.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.

WARNING: Use only D
Inserting and Removing the Battery Pack
from the Tool (Fig. C)
nOTE: Make sure your battery pack
To Install the Battery Pack into the Tool
Handle
1. Align the battery pack 6
handle (Fig. C).
2. Slide it into the handle until the battery pack is firmly seated
in the tool and ensure that you hear the lock snap into place.
To Remove the Battery Pack from the Tool
1. Press the release button
out of the tool handle.
2. Insert battery pack into the charger as described in the
charger section of this manual.
OPERATION
Instructions for Use

WARNING: Always observe the safety instructions and
applicable regulations.
WALT
e
; the maximum length
2
WALT battery packs and chargers.
e
6 is fully charged.
with the rails inside the tool's
5 and firmly pull the battery pack