Operating Conditions - El-Björn ASE 300 Manual

4 Transport and installation
Transport
Crushing hazard!
The adsorption dryer is heavy.
Use only the handle to carry the adsorption dryer.
Do not reach into the openings.
Material damage
Pulling the power cable may damage the cable.
Always disconnect the mains plug from the socket outlet before transport of the device.
Always use the carrying handle to lift the device.
1. Report any obvious damage to the carrier, parcel service, postal service etc. immediately on delivery and
note down the damage on the shipping document or carrier's document.
2. Remove the packaging material completely and dispose of according to the local regulations.
3. Check the delivery for completeness.
4. Should any transport damage be detected after unpacking of the device, or should the delivery be incom
plete, contact your salesman in charge or specialised dealer without delay.
5. Use the carrying handle to transport the adsorption dryer to the to the place of installation.

Operating conditions

Series ASE adsorption dryers are suited for mobile or stationary use on building sites, in storage rooms, cellars,
garages, on boats and in caravans. ASE adsorption dryers work without problems in the temperature range from
-10 °C to +35 °C and in the humidity range from 10 % to 95 % relative humidity.