Yeacomm P11K User Manual

YEACOMM P11K User Manual
Thank you for choosing Yeacomm YF-P11K 4G wireless router Wifi
Kit, please read and keep the user manual carefully.
1. Main Technology Parameters
●Working temps : -30℃ -- +60℃
●Relative humidity: 5%--95%
●Working frequency :
LTE: B1/2/3/5/7/8/20/38/40
LTE: B1/2/3/5/7/8/28/38/39/40/41(Optional)
●Power supply : input AC :100V~240V，50Hz~60Hz
Output DC: 15V, 1000mA
●Size: 252mm*112mm*58mm (Outdoor Unit)
105mm* 95mm*20mm (Indoor AP)
● Rate of uplink and downlink: LTE(Cat 4) 150Mbps/DL ；
50Mbps/UL
2. Product Interface and Indicator
2.1 Product interface
2.11 Outdoor router interface introduction
2.12 Indoor AP interface introduction
2.2 Indicator
2.21 Outdoor unit indicator
Type Status Description
no signal (the signal status can be
RF All off
checked in the terminal configuration
page)
Signal is poor
One on
Signal is moderate
Two on
Signal is good
Three on
Signal is very good
All on
Power abnormal, the router power off
SYS Off
Power normal, the router power on
On
No SIM or can not detect SIM card
SIM Off
Device read the SIM normally
On
Device doesn't connect to PC
ETH Off
Device connects to PC
On
Device is not running
RUN Off
Device is running
On
2.22 Indoor unit indicator
Indicator status Description (from left to right )
type
Off Power abnormal, the router power off
POWER
On Power normal, the router power on
Off no signal
(the signal status can be checked in the
terminal configuration page)
SIGNAL
Red The signal is poor
Yellow Signal is moderate
Green Signal is good
Off WiFi off
WLAN
Flicker WiFi on and has data transmission
Off Outdoor unit do not connect with
indoor unit .
DATA
On Outdoor unit connects with indoor
unit .
Off Outdoor unit does not connect with
WAN indoor unit .
Light Outdoor unit connects with indoor unit
LAN1/ Off Do not connect with PC
LAN2 Light Connect with PC correctly
3. Installation
3.1 Insert the sim card as below. When you hear a clicking sound, it
means that the USIM card has been installed successfully.
3.2 Connect the wan port of the indoor AP to the outdoor cpe router's
POE port by Cate5e cable.
3.3 Place the outdoor unit outside in open space, the front panel face
to the base station. Make sure the unit is fixed well.