Table of Contents
Advertisement
RADIO
You can use this set solely as a radio!
1 Adjust RADIO ON/OFF to ON to switch on the radio.
2 Select your waveband by adjusting the BAND switch.
3 Adjust TUNING to tune to your desired station.
4 Turn the VOLUME control to adjust the volume level.
5 Adjust RADIO ON/OFF to OFF to switch off the radio.
To improve reception:
FM:
extend and position the pigtail for optimum reception.
AM (MW):
SETTING THE CLOCK AND ALARM TIME
The time is displayed using the 12-hour clock
IMPORTANT! To adjust the clock and alarm times accurately, always make sure
you press UP / DOWN separately and not simultaneously.
1 Turn the clock control to SET TIME or SET AL 1 or SET AL 2 to set the
clock or alarm time respectively.
2 Press UP / DOWN repeatedly or hold down on the respective button to adjust
the hours and minutes.
3 Release UP / DOWN when you reach the correct setting.
4 After you have set both the hour and minutes, turn the clock control to
CLOCK to run on clock time.
SELECTING THE ALARM MODE
GENERAL
If you wish to use the alarm, you must first set the alarm time first. You can
choose from two different alarm modes to wake you up: by radio or buzzer.
• Select your choice of alarm mode by adjusting AL 1 or AL 2 to RADIO or
BUZ.
™ The buzzers are at a set volume and cannot be adjusted. BUZ on AL 1 is a
low tone buzzer while BUZ on AL 2 is a high tone.
uses a built-in aerial inside the set. Direct the aerial by
adjusting the position of your set.
Advertisement
Table of Contents
