Procedure B: Light Controller Setup - Nasco CPARLENE 3000 Series Instruction Manual

Adult/Child
Switch on All
Monitors Monitors
Light Controller Light Controller
Three-color light controller indicates acceptable Three-color light controller indicates acceptable
levels. Red flashing light indicates improper
hand placement, green flashing light indicates
proper ventilation volume, and yellow flashing
light indicates proper compression depth. Child
CPR can be practiced by changing the com-
pression springs from black (adult) to red, and
switching to Child setting on the back of the
light controller.
PROCEDURE B: Light Controller/Setup
Remove the cover using a medium- sized
Phillips head screwdriver. Batteries are includ-
ed (use "C" cell alkaline batteries).
Figure 14
Operation
1. Locate the electronic interface jack
inside the manikin torso and thread
through a hole on either the left or right
side of the torso. (See figure 14.)
2. Insert jack into light controller.
3. Set light controller to adult or child
mode using switch.
Hand Placement (Red Light)
The red placement light will illuminate every
time the chest is compressed 1.00 inch and
the proper hand placement has not been
accomplished.
LF03403U
Ventilations (Green Light)
Adult Setting: The green ventilation light
will illuminate every time the ventilation of
0.80 liters is reached. It will turn off when
volume drops below this level.
Child Setting: The ventilation light will
illuminate every time the ventilation of 0.50
liters is reached. It will turn off when volume
drops below this level.
Compressions (Yellow Light)
Adult Setting: The yellow compression light
will illuminate every time the compression
depth of 2.00 inches is reached. It will turn off
when it drops below this depth or if it exceeds
2.50 inches.
Child Setting: The compression light will
illuminate every time the compression depth
of 1.75 inches is reached. It will turn off when
it drops below this depth or if it exceeds 2.25
inches.
17