Table of Contents
Advertisement
fig.13
5.4.3.
to connect the air hose, detach the adapter of the Ø8 Pu hose on the side of the body. this adapter has the function to prevent the
hose from sliding into the body. Insert the adapter into the elbow. See the fig.14 and fig.15.
fig.15
5.4.4.
Connect the inflation gun fig.16. Then connect the air source.
5.4.5.
the air regulator has been adjusted before leaving the factory.
if it needs adjusting, the air pressure can be adjusted by lifting
the button fig.17.1 and turning clockwise to increase and anti-
clockwise to decrease. to adjust the oil feed use a screw driver
to turn screw fig.17.2, clockwise to decrease flow, anti-clockwise
increase flow.
6. Demount anD mount tyre
6.1.
Demount tyre
6.1.1.
Deflate the air in the tyre completely and remove the valve. Use a special tool to detach any weights on the rim, fig.18.
fig.18
6.1.2.
Place the tyre between the bead breaking blade and rubber tyre block. Position the bead breaking blade beside the lateral side of the
tyre fig.19. Then operate the pedal to detach the rim from the tyre fig.2.10.
© Jack sealey limited
Original Language Version
fig.14
fig.16
tc10 | issue 1 02/02/18
fig.17
fig.19
Advertisement
Table of Contents
