Table of Contents
Advertisement
2. Safety
2.1.
electrical Safety
Warning! it is the user's responsibility to check the following:
‰
check all electrical equipment and appliances to ensure that they are safe before using. inspect power supply leads, plugs and
all electrical connections for wear and damage. sealey recommend that an rcd (residual current device) is used with all electrical
products. You may obtain an rcd by contacting your local sealey dealer.
if the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAt (Portable
Appliance test) tested.
electrical safety information, it is important that the following information is read and understood.
2.1.1.
ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
2.1.2.
regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
2.1.3.
important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse - see fuse rating in these instructions.
Do not pull or carry the appliance by the power cable.
8
Do not pull the plug from the socket by the cable.
8
Do not use worn or damaged cables, plugs or connectors. ensure that any faulty item is repaired or is
8
replaced immediately by a qualified electrician.
2.1.4.
This product is fitted with a BS1363/A 13 Amp 3 pin plug.
if the cable or plug is damaged during use, switch off the electricity supply and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
a) connect the Green/YelloW earth wire to the earth terminal 'e'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Sealey recommend that repairs are carried out by a qualified electrician.
2.2.
general Safety
Warning! ensure that Health & safety, local Authority regulations and general workshop practice regulations are adhered to
‰
when using tyre changer. read and fully understand instructions and safety labels attached to machine.
Wear appropriate Personal Protective equipment. A full range of Personal Protective equipment is available from your sealey stockist.
9
Wear suitable clothing to avoid snagging. Do not wear jewellery. tie back long hair.
9
maintain machine to ensure it is in an adequate condition for safe use and optimum performance.
9
Do not use tyre changer if damaged.
8
this machine should only be operated by trained personnel.
9
This machine should only be used for the purpose for which it is intended and not modified in any way.
9
The tyre changer must only be operated with specified voltage and air pressure.
9
Warning! the warnings, cautions and instructions in this manual cannot cover all possible conditions and situations. the operator/
‰
user must apply caution and common sense.
2.3.
WarningS anD PrecautionS
Make sure Tyre Changer is fitted/used on a dry, flat, level, oil/grease free, concrete surface capable of supporting the weight of the
9
tyre changer.
Before each use, always examine the Tyre Changer for structural cracks/defects, damage to the clamping jaws and electrical wiring,
9
and any other condition that may affect the safe operation of the machine.
Do not use the tyre changer if any defects are found.
8
maintain a safe working environment. Keep the work area well lit. make sure there is adequate surrounding workspace. Always keep
9
the work area free of obstructions, grease, oil and other debris.
Do not use the tyre changer in a damp or wet location.
8
Do not use the Tyre Changer in areas near flammable chemicals, dusts and vapours.
8
this tyre changer is designed for use with most passenger cars and light commercial wheels.
9
Do not attempt to exceed this machine's maximum wheel diameter of 24".
8
Always keep hands, fingers, and feet away from the moving parts of the Tyre Changer while machine is in use.
9
Always turn off mains power when not in use.
9
Before using the machine, make sure tools and all other equipment is removed from the immediately vicinity.
9
Do not use with an extension cable. tyre changer needs to be mounted near a suitable plug socket.
8
Always unplug the tyre changer from its electrical supply before performing any inspection, maintenance, or cleaning procedures.
9
Warning: People with pacemakers should consult their physician(s) before using this product. operation of electrical equipment in
‰
close proximity to a heart pacemaker could cause interference or failure of the pacemaker.
2.4.
unPacKing
When unpacking, check to make sure all parts shown on the Packing lists are included. if any parts are missing or broken, please call
your sealey distributor.
© Jack sealey limited
Original Language Version
recommended fuse rating
13 Amp
tc10 | issue 1 02/02/18
Advertisement
Table of Contents
