Summary of Contents for King Canada KDL-11
- Page 1 DRYWALL & PANEL LIFT MODEL: KDL-11 INSTRUCTION MANUAL COPYRIGHT © 2007 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
- Page 2 Canada service center. Contact your retailer or visit our web site at www.kingcanada.com for an updated listing of our authorized service centers. In cooperation with our authorized serviced center, King Canada will either repair or replace the product if any part or parts covered under this warranty which examination proves to be defective in workmanship or material during the warranty period.
- Page 3 DRYWALL LIFT ASSEMBLY SETTING-UP TRIPOD BASE AND INSTALLING LOCKING CASTERS 1) Place the tripod base assembly on the ground and then press down on the slide yoke ring (A) Fig.1 and hold the ring down and swing the legs out completely until the slide yoke ring snaps into the locking hole on the bottom of the slide tube.
- Page 4 DRYWALL LIFT ASSEMBLY ASSEMBLING THE WINCH HANDLE 1) Assemble the winch handle (A) Fig.5 to the winch wheel by tightening the handle bolt (B) with a screwdriver. FIGURE 5 INSTALLING THE CRADLE ASSEMBLY TO THE TOP OF FRAME 1) Before attempting to install the cradle to the top of the frame, pivot the retaining hook (A) Fig.6 downdards.
-
Page 5: Operating Controls
OPERATING CONTROLS ADJUSTING OUTRIGGERS The outriggers (A) Fig.8 at both ends of the cradle (B) extend for supporting longer drywall panels. To extend the outriggers; 1) Pull out the lock pin (C) until you can slide the outrigger (A) out. 2) The lock pin can engage to lock the outrigger at one of three positions: fully retracted;... - Page 6 LOADING & RAISING DRYWALL PANEL LOADING DRYWALL PANEL Before attempting to load a drywall panel, it is important that you have familiarized yourself with all safety rules, specifications, capacities and have followed all the assembly instructions in this manual. To load a drywall panel; 1) Lower the foot brake so the drywall lift won’t roll backwards.
-
Page 7: Maintenance And Storage
8) Fold the tripod base by pressing down on the slide yoke ring and pivot the forward legs in until they lock in the closed position. PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.