Advertisement
4. OPERATION
WARNING! Ensure you read, understand and apply the safety instructions in Section 1.
If you have no experience of using a scroll saw, it is recommended that you practice until you have familiarised yourself with the
applications, limitations and hazards of the saw.
Keep alert. DO NOT allow familiarity (from frequent use) to cause a careless mistake. Remember, a careless second is sufficient
to inflict damage or serious injury.
4.1.
set blade to front or side cutting as required, set table angle, adjust guard to just clear workpiece (so that fingers cannot touch blade)
and align blower tube to keep cut line visible.
4.2.
Plug saw into mains power and switch on.
4.3.
Workpiece may now be guided slowly into the blade taking care to keep the workpiece pressed down firmly onto the table. do not
bend or twist the blade as this will cause it to break.
5. MAINTENANCE
5.1.
Keep table clean to give easy and smooth movement of workpiece.
5.2.
every 50 hours of use oil the lower arm bearings with sAe20 oil. Access bearings from rear of machine.
6. TROUBLESHOOTING
PROBLEM
CAUSE
1) Incorrect tension
Breaking blades
2) over-worked blade
3) Wrong blade
4) twisting blade with workpiece
Motor will not
1) Power supply fault
operate
2) Motor fault
Vibration
1) Mounting or mounting surface
2) loose table
3) loose motor
Blade run-out
1) Blade holder(s) misaligned
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
SOLUTION
1) Adjust blade tension.
2) feed workpiece more slowly.
3) use narrow blades for thin workpieces, wide blades for thick.
4) Avoid side pressure, or twist, on blade.
1) check power supply and fuses.
2) contact local authorised service Agent.
1) ensure mount bolts are tight. the more solid the surface the
2) tighten table lock knob and pivot screws.
3) tighten motor mounting screws.
1) loosen blade holder screw(s) and realign.
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk,
IP32 7Ar
Original Language Version
less the vibration.
www.sealey.co.uk
01284 757500
Web
sales@sealey.co.uk
01284 703534
email
sM43.V3
Issue: 5 - 07/01/10
Advertisement
