Advertisement
I
N
S
T
A
I
N
S
T
R
1. Switch off the host computer and peripherals before connecting
the SCSI cable.
2. Make sure the SCSI connectors are seated properly.
3. If this unit is the last (or only) device on the SCSI bus, make sure
to connect a SCSI terminator to the open connection. If another
device will be added to the SCSI chain after the SDT-S11000, put a
cable from the SDT-S11000 to the device. The end of the SCSI bus
must always be terminated.
SCSI ID Selector
Power Cord
4. Set the SCSI ID:
Wide SCSI allows SCSI addresses from 0 to 15. Each device
requires a unique address. The SCSI address of the SDT-S11000
must be different from any other device on the SCSI bus,
including the SCSI address of the host.
Before setting the SCSI address, turn off the power by using the
POWER switch on the front panel.
SCSI ID is set by the rotary switch on the rear panel. Press
the + or - buttons to move the number up or down, respectively.
5. Connect the power cord.
6. Power on the host computer, load the software and the
SDT-S11000 is ready for use!
2
L
L
A
T
I
O
N
U
C
T
I
O
N
S
SCSI Cable
SCSI Terminator
(Use SCSI Cable if going to
another device)
SDT-S11000 DDS Quick Start Card
G
E
N
E
I
N
S
T
R
1. Press the POWER button on the front panel. The POWER
indicator should light, and the STATUS, BUSY and TAPE
indicators should blink as the self-test is performed.
2. When the three indicators stop blinking, you can insert a data
cartridge as shown below. The TAPE indicator will blink, and if
the cartridge is write-protected, the STATUS indicator will light.
3. Computer software controls the reading and writing of tapes.
While reading or writing, the BUSY indicator blinks.
EJECT Button
BUSY Indicator
(regular blinking Ð drive
is ready or writing
TAPE Indicator
B U S
(regular blinking Ð
inserting/removing a
cartridge.
alternating
long-short
blinking Ð cartridge
deteriorated.)
STATUS Indicator
(repeated long on, short off blinking Ð drive needs cleaning.
blinking regular interval Ð end of tape during cleaning.
repeating short on (once or twice), long off blinking Ð drive
is malfunctioning.
To remove cartridges: Press the EJECT button. The cartridge ejects
automatically. CAUTION: Do not push the EJECT button while the
BUSY indicator is blinking as it may destroy data on the tape.
Write protect
switches
Write protected, tab left
Write enabled, tab right
SDT-S11000 DDS Quick Start Card
R
A
L
U
S
E
U
C
T
I
O
N
Y T
A P E
S T A
T U S
Power Button
Power Indicator
(lit when drive on)
Write Protection of data
cartridges: To change the
Write protect switch:
using your fingernail,
push the switch as
shown in the illustration.
S
3
Advertisement
